easypal setup windows 7 cannot find path

Too high or too low a signal level from your Receiver via your Radio Interface to your PC soundcard will result in Total or partial LOSS OF RECEIVE SIGNAL.ĮasyPal will correctly receive and decode when ALL RECEIVE INDICATORS SHOW GREEN.Ĭommonly referred to as the TRAFFIC LIGHTS the Indicators consist of a vertical stack of Five Indicators titled SYNC to the top left of the RX/TX/VIEW Window. The levels selected relating to INPUT will have a direct effect on EasyPal's ability to correctly decode Pictures.

A shortcut to your PC Volume control can frequently be found on your Windows Taskbar.įor those users who have Multiple Soundcards installed in their PC systems it is vitally important that the correct soundcard is selected for any level changes to have an effect on your transmitted or received signals. The level of TRANSMIT Audio from your PC to Transmitter should likewise be adjusted with the controls of your Radio Interface or PC Soundcard Volume controls.

You should set the LEVEL of the signal you RECEIVE by adjusting the controls of your PC to Radio Interface (if present) and / or the RECORD / INPUT controls within your PC Soundcard software. SOUNDCARD Select the INPUT and OUTPUT devices for your computer system here. Your Callsign is transmitted within the Header information and will be displayed in the Receive Callsign window when your transmission is being received correctly. A Callsign MUST be entered for Transmission to be allowed. Especially Important for Windows 7 Users.ĬALLSIGN Enter your CALLSIGN here.

It is included for those users who prefer the Windows Standard Dialog over the EasyPal Load Dialog and may be preferred in some Windows versions where users are not fully conversant with how the Windows file system works. Select this option if you prefer to use the standard Windows load feature. USE WINDOWS OPEN DIALOG For use with the LOAD PIC and LOAD ANY Commands

Easypal setup windows 7 cannot find path